Active IQ and AutoSupport Discussions

How can I trigger automatic AutoSupport messages when adding a new disk shelf to a system?

WASZKIEWICZ
3,896 Views

Hi!

I would like to configure my AutoSupport on my 6080 in order to send informative messages as soon as a new disk shelf is connected to it.

Is it possible?

Is it already the case? If yes, what is the subject of the automatically triggered message?

Thanks a lot for your help!

Cheers,

R.

1 ACCEPTED SOLUTION

WASZKIEWICZ
3,896 Views

So I guess if the shelf is added to an existing loop, an AutoSupport message will be triggered as soon as the MultiPath is broken in order to add the shelf.

In case of the creation of a new loop, there will be no AutoSupport message.

Source: NetApp Senior Consultant.

Thanks for your help.

View solution in original post

3 REPLIES 3

eric_barlier
3,896 Views

How can I trigger automatic AutoSupport messages when adding a new disk shelf to a system?

This one is hard to test of course but Im pretty sure that if you scan /etc/messages on the controller you ll see that new hardware

has been attached. I suspect ASUP will not be fired off as its not an error to add a shelf.

Hope this helps,

Eric

WASZKIEWICZ
3,896 Views

Salut Eric,

En effet, il faudra contrôler le contenu des WEEKLY_LOG.

Merci pour ta réponse!

Ronald W.

WASZKIEWICZ
3,897 Views

So I guess if the shelf is added to an existing loop, an AutoSupport message will be triggered as soon as the MultiPath is broken in order to add the shelf.

In case of the creation of a new loop, there will be no AutoSupport message.

Source: NetApp Senior Consultant.

Thanks for your help.

Public