Subscribe
Accepted Solution

Is Snaprestore needed

What is the process of accessing volume snapshots in a read and write fashion to recover data if you do not have a SnapRestore license?

Example: A lun containing VMs is snapped a few times per day, one of the VMs is destroyed by a virus. To recover the VM can one of the snapshots be mounted and accessed so the VM can be storage vmotioed from the snapshot back to the original lun.

Is this possible without snaprestore???? 

Re: Is Snaprestore needed

You can use "lun clone" to create a clone of the LUN based on a specific snapshot.

Re: Is Snaprestore needed

This would require FlexClone to clone the Snapshot - Is there no other way of accessing the Snapshot and access the data (read/write)?

Re: Is Snaprestore needed

LUN cloning actually doesn't require FlexClone license - only volume-level cloning does.

I am not 100% sure though whether it will work without SnapRestore license enabled (it is always listed as a prerequisite for SnapManager products, which use LUN/volume cloning for restore operations).

Regards,

Radek

Re: Is Snaprestore needed

So you can clone a lun without flexvol? This would require 100% of the base lun size?

In this design we would not be using any snapmanager products, only the built-in snapshot mechanism (I know this cash consistent only!!) - Can anyone help answer the question "can you clone a snapshot of a lun without snaprestore"?

Re: Is Snaprestore needed

You can use lun clone without a flex_clone license.  At first that clone only needs to take up the changed space from the original.  However if you want to keep that clone around long-term, you will want to split it off so you will need enough space in the containing volume for the entire LUN.  After that you could get rid of the original.

Re: Is Snaprestore needed

Radek Kubka wrote:

I am not 100% sure though whether it will work without SnapRestore license enabled (it is always listed as a prerequisite for SnapManager products, which use LUN/volume cloning for restore operations).


For the lun cloning a snap restore license is not needed.

In the past the snapdrive software used the snap restore command to restore a lun. But this has been changed to lun clone/split, probably because this is faster than waiting for a restore. Why snap restore is still required I don't know, perhaps for volume snap restores.

Re: Is Snaprestore needed

Thanx everyone - One last thing... If you do use lun clone to clone and access a snapshot, should the clone be located in it's own temporary flexvol until you are finished with it?

Re: Is Snaprestore needed

If you do use lun clone to clone and access a snapshot, should the clone be located in it's own temporary flexvol until you are finished with it?

No, not really - that would mean 100% capacity overhead (unless this is a FlexClone operation). The side effect of LUN clone is that backing snapshot appears as 'busy' (can't be removed) until you either delete or split a clone.

Re: Is Snaprestore needed

By definition, a LUN clone must exist in the same volume as it's source.  If you want a temporary separate volume, that's a Flex Clone and that's a licensed product.