2015-05-12 04:09 AM - last edited on 2016-06-30 03:45 PM by Li-Jacques
Here we have a netapp FAS2552, would like to factory reset it and re-configure everything (all except zero the aggregate again since it is time consuming ; If it is needed, then it is okay)
Is there any procedure to do so?
I am not sure the labels as required by netapp is right. I just know it is dataontap.
Solved! SEE THE SOLUTION
2015-05-12 08:56 AM
what are you trying to do?
there are a couple of ways to reconfigure a filer, can be as simple as just rerun setup and the commnad line, down to using full factory reset type commands from outside of OnTap.
maybe, if you could let us know what you are tyring to reconfigure, can maybe offer some suggestions.