ONTAP Discussions

Error reading/writing to network, connection dropped.

VAIBHAVMISHRA
8,629 Views

Hi,

Recently I have observed the following Snapmirror error in my source filer. Tried searching related thread but in vein.

Can some expert have their comments on this as what could be a possible root cause behind.

snapmirror.src.connDropped:error]: Error reading/writing to network, connection dropped.

last message repeated 20 times

Thanks,

VM

6 REPLIES 6

sudheerns76
8,630 Views

I am out of the office until 25/03/2012.

I am not available from 23rd to 25th March due to Public Holiday in

Bangalore and I will be out of station . Please reach out to Steve

Lee/India/IBM, for any Solution queries in my absence. For any management

queries please reach out to Sundar Subramanian1/India/IBM.

For emergency I can be reachable on Mobile Numbers - 9900111441 /

9886395241.

I Apologies for any Inconvenience and Thanks in Advance for your

co-operation.

Note: This is an automated response to your message "[Products &

Solutions] - Error reading/writing to network, connection dropped." sent on

23/3/12 13:58:07.

This is the only notification you will receive while this person is away.

sgrant
8,630 Views

I encountered the same message "error reading/writing to network". I traced the problem in the /etc/log/snapmirror log. The problematic SnapMirror relationship was identified by the "Request" then subsequent line "Abort (connection to destination dropped)". Once I had resolved that problem the errors stopped. In my case the destination volume was too small, an easy solution!

Cheers,

Grant.

LTDCLSERGAO
8,630 Views

Hi Grant,

I  have just had the same message. the destination volume was too small. Thanks

Said

pavila
8,630 Views

I've seen this before myself and I've also seen the error that tells us that the destination volume is too small. This particular error message is misleading and has the tendency to create a 'wild goose chase' to resolve it.

eperrier
8,047 Views

I am also having this same issue. What causes this error?

 

 

snapmirror Error reading/writing to network, connection dropped

 

ARCOHAKNL
8,036 Views

Hi,

 

If you receives these messages, it could be a resolving issue.

Can you check if the resolving points to the e0M entry?

Also check the interface the connection should go, and it's not blocked for traffic.

In most cases DNS or the host file has an entry for the filername  that points to the management interface.

If your snapmirror connection use that entry(name), and data traffic is allowed on your management interface, this kind of messages appear.

Create an entry of the name in the host file with the right IP address solves it.

 

Arco

 

 

 

Public