ONTAP Discussions

FAS8020 Converted to CDOT and Upgraded to OnTap 9 - Missing e0c and e0d Ports

dartfordbc
2,627 Views

Hi

 

We have zeroed our FAS8020, converted to clustered, upgraded to OnTap 8.3 from 8.2.4 and then upgraded to OnTap 9.1

 

Previously we didn't have an Cluster Interconnect as it was 7 Mode. I used e0a and e0b fibre ports to interconnect. I want to use e0c and e0d on each node for my data network but they do not show in OnCommand management and they do not show when I do ana ifconfig -a

 

I can't find anything on the internet about it.

 

Please help.

 

 

1 ACCEPTED SOLUTION

SeanHatfield
2,569 Views

First guess, the ASIC is in FC mode.

 

Try:

system node hardware unified-connect show

If so you have to put them in cna mode with

system node hardware unified-connect modify

Then reboot each node.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

View solution in original post

2 REPLIES 2

asulliva
2,611 Views

What do the commands "net port show" and "net int show" report?

 

Andrew

If this post resolved your issue, please help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

SeanHatfield
2,570 Views

First guess, the ASIC is in FC mode.

 

Try:

system node hardware unified-connect show

If so you have to put them in cna mode with

system node hardware unified-connect modify

Then reboot each node.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.
Public