Subscribe

How do we know controller is running in cifs or nfs protocol?

As per topic

Re: How do we know controller is running in cifs or nfs protocol?

7-mode or cdot.. Check the services  

Re: How do we know controller is running in cifs or nfs protocol?

i know those modes but which services should I check?

Re: How do we know controller is running in cifs or nfs protocol?

If you are running cdot

 

cifs show

nfs show

 

Re: How do we know controller is running in cifs or nfs protocol?

How about 7 mode?

Re: How do we know controller is running in cifs or nfs protocol?

In 7 mode, use” nfs show” command to check the status of the NFS service.

For CIFS you can use to command “cifs shares”  If CIFS protocol is enabled it will display all the shares however if it’s not enabled it will give you a message “CIFS not running” 

Similarly if you type the command “cifs ? “ it will give you the commands associated to CIFS however if CIFS protocol is not running than it will give you a message “CIFS not running”

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.