ONTAP Discussions

Is it safe to perform giveback?

GrumpyOldMen
2,906 Views

On a FAS2240-4 cluster running ontap version 8.1.2 in 7-mode. Status of the nodes:

 

Node 1: node1 has taken over Node2

Node 2: waiting for giveback

 

When doing a 'cf giveback', I'm getting the following message :

 

Partner not waiting for giveback, giveback cancelled.

To do a giveback without checking for partner readiness, please either set option "cf.giveback.check.partner" to off before doing "cf giveback" again or do "cf giveback -f".

 

I have the impressing this is the case because of the following reason:

 

  slot 0: Interconnect HBA: Mellanox IB MT25204
GUID: 0x100000a0983871ae LID: 0x4 Remote LID: 0x0
Firmware rev: 1.0.800
Hardware rev: 160
Command rev: 1
Cluster Interconnect Port: port not active

 

I guess a "cf giveback -f" will not succeed... Right?

 

Any suggestions?

 

 

 


 

3 REPLIES 3

Sahana
2,833 Views

Hi,

 

Please refer KB https://kb.netapp.com/support/s/article/ka21A0000000fj6QAA/can-the-cf-giveback-f-command-be-disruptive?language=en_US 

However if the interconnect has a failure then the nodes cannot communicate and the giveback will fail.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

GrumpyOldMen
2,786 Views

I did the giveback by using -f. All apllications and access to Netapp filer was stopped. But now I'm stuck with an interconnect issue...as I expected. Will be continued.

GrumpyOldMen
2,743 Views

FAS2240-4 with error interconnect down. Any ideas?

Public