Subscribe

LREP command

[ Edited ]

Hello everyone,

i'm trying LREP for the first time and i can't seem to find whats wrong with my command. Can anyone help me point?

lrep_reader.exe -p snapvault_start -f OFFSITENAS01 -q /vol/TESTDATA/TESTDATA -o E:\test@0 -l reader.log 192.168.1.1:/vol/TESTDATA/TESTDATA

Transfer rejected: source qtree does not exist.

Thank you in advance!

Regards,

CH

Re: LREP command

all it is in this document http://www.peripheralstorage.com/NetApp/pdfs/OSSVBestPractices.pdf  s56-57

good luck

Re: LREP command

Hi,

Try the following syntax

lrep_reader -p snapvault_start -f 172.16.0.211 -q /vol/max_fs/max_fs -O
-o c:\temp\file@0 192.168.210.8:/vol/max_fs/max_fs

All the best

TS

Re: LREP command

i can't seem to find whats wrong with my command. Can anyone help me point?

 

lrep_reader.exe -p snapvault_start -f OFFSITENAS01 -q /vol/TESTDATA/TESTDATA -o E:\test@0 -l reader.log 192.168.1.1:/vol/TESTDATA/TESTDATA

 

Transfer rejected: source qtree does not exist.

 

Yes, your error is that the Source Qtree does not exist, or is spelled wrong.  This is the data you are wanting to test a backup on  (192.168.1.1:/vol/TESTDATA/TESTDATA).  Verify that you have created that Qtree and everything is spelled correctly, including CASE.