Subscribe

Meaning of MetroCluster Status Error? (7-mode)

Can anyone provide insight on the following error message?  What type of MetroCluster error may have occured to generate this message?  Are there any commands I can run to find out more info?

 

node-01: node-02: Metro Cluster Status Error Do you wish to proceed with system start? ([n],y)

 

If I answer "y", the system appears to come up fine.

 

But the fact it is asking me, I assuming there is some sort of MetroCluster error.  Trying to figure out some more specifics.

 

Any insight appreciated.


Thanks,

Joyce

 

 

Re: Meaning of MetroCluster Status Error? (7-mode)

 

Joyce -

 

Given that I'm teaching MetroCluster for a client in India this week this post realy caught my attention !

 

Best guess is that there was an unkown failure of the cluster, and the systems weren't sure of the state before the failure.

It was probably a check to prevent a bad resync if there was a split brain scenario.

 

I'd want to check the logs on both sides of the cluster to see what happened before the break.

I probably would have isolated the down system and done this before proceeding with bringing the failed node back online.

 

Thank you for this timely question.

I'll probably use it as a teaching example in the morning.


I hope this response has been helpful to you.

At your service,

Eugene E. Kashpureff, Sr.
Independent NetApp Consultant http://www.linkedin.com/in/eugenekashpureff
Senior NetApp Instructor, IT Learning Solutions http://sg.itls.asia/netapp
(P.S. I appreciate 'kudos' on any helpful posts.)