2013-04-23 04:46 AM
I am using ontap v7, and am looking to move a volume from aggregare to another aggregate on the same filer. This volume is also a snapvault destination and also setup as a share. The snapvault source is on another filer. So i guess moving a volume from one aggregate to another we can use snapmirror. But what do we need to do the snapvault relationshiop to continue the sync, as i dont want to basline the relationship again. Any ideas on steps on doing this move including the snapvault work
2013-04-23 06:42 AM
You can doit like its descripted under Following link on Site 110:
- snapmirror start
- snapmirror quiesce
- snapmirror break
- snapvault start -S (with the new Volume)
--> Following Message occurs
Snapvault configuration for the qtree has been set.
Qtree /vol/new_vol/bno_C_500MB is already a replica.
- snapvault update
2013-04-24 12:45 AM
Do you use DFM? IF so you can use the secondary space management wizard to migrate the destination volume to another aggr. It would preserve your relationship.
2016-05-19 04:48 AM
Good documentation, thank you!
I successfully moved my old snapvault destination volume using snapmirror to another volume, is it possible to move the existing snapvault_snapshots from the old volume as well? I run a backup filer and want to keep the existing daily snapvault_snapshots in the new volume.
Is this possible?