ONTAP Discussions

Network maintenance and netapp cluster

rpalacios
3,044 Views

Hello Guys,

The networking team will be performing some network maintenace which will affect connectivity to 2 (clustered) NetApp heads. Is there anything else other than cf disable that I need to do in order for the cluster not to fail?

Thanks!!

-rp

4 REPLIES 4

scottgelb
3,044 Views

Unless you have both "options cf.takeover.on_network_interface_failure on" and "nfo" on the ifconfig of any interfaces, the network drop will not cause a failover.  You can check the options and also ifconfig -a to see if nfo is applied to any interface.  By default, network failover is not configured in options and also has to be enabled in /etc/rc on the ifconfig lines.  If you are running nfo, you can "ifconfig interface -nfo" on each interface to remove nfo, then "ifconfig interface nfo" to re-enable after maintenance.  This might be a better option than cf disable since cluster failover would still be available for any other non-network hardware failures during the maintenance

rpalacios
3,044 Views

Hello Scott,

I checked the rc config and did not see any settings related to "nfo." Here's the output of the 'options cf.takeover.on_network_interface_failure' command. It looks like it is disabled.

NetApp> cf.takeover.on_network_interface_failure off

What would be the best approach for this scenario?

Thanks,

-rp

scottgelb
3,044 Views

From the settings a drop in the network will not cause the cluster to failover if only the network drops.

Typos Sent on Blackberry Wireless

rpalacios
3,044 Views

Great. Thank you Scott.

Public