Subscribe

ONTAP 8.2 7-Mode Simulator configuration issue

When beginning the initial configuration of my simulator it asks to configure the Interface group.  I select yes, and then all I get is this continuing string of "No IP addresses specified.  Please set an IP address."  It just keep streaming, and does not stop.  It is shortly interrupted by some system messages, but the IP message never stops.  No Ctrl+D will stop it, etc.  My only option is to power off the VM and start over with the same result.  I even tried to configure the simulator with no interface groups, but I get the same issue.

Re: ONTAP 8.2 7-Mode Simulator configuration issue

Seems it is corrupted can download a another copy of simulator from Netapp support site and try again....

 

Thanks,

Nayab