ONTAP Discussions

Snapmirror resume and resync after destination controller shutdown

arsalankhan
2,358 Views

HI ,

 

I am new to snapmirror and i would like to know whtat is the procedure to re-enable , resume or resync the snapmirror on destination volume after change the ipadresses and powered off the destination controller .

 

For example 

 

I have two HA pair systems FAS2554 running data ontap 8.2 7- mode .I have to change the ippaddressess and network configuration setting on the Destination system and gracefully shutdown that  controller after that i need to re -sync or re-enable the snapmirror again . what are the steps to do that ?

 

Snapmirror status is on idle right now .

 

Regards,

 

Arsalan 

3 REPLIES 3

aborzenkov
2,339 Views
Did you check that new IP is allowed snapmirror access on source?

arsalankhan
2,320 Views

Yes its already added in snapmirror.access and i want to know the steps prior shutting down the controller and after changed the ipaddress and then renable snapmirror .

aborzenkov
2,219 Views

It should just work. SnapMirror works in pull mode, so destination should simply continue existing relationships as long as new IP is allowed for SnapMirror access to source.

Public