Subscribe
Accepted Solution

cDOT CLI >igroup show

Hi

 

In 7-mode you can run the igroup show -v command and see which target port an initiator is logged in on. Is there an equivalent command in cDOT?

 

Thanks

Re: cDOT CLI >igroup show

Hi,

 

you can always use

 

-instance

 

in the command line to get more output.

 

M.

Re: cDOT CLI >igroup show

Thanks, I know about the -instance switch. My question was about running a command which shows which target port an initiator is logged into, the -instance switch doesn't show this.

Re: cDOT CLI >igroup show

You can use "iscsi initiator show" to list initiators and target portals they are logged into and "iscsi interface show" or "iscsi portal show" to match portals and interfaces.

Re: cDOT CLI >igroup show

Thanks for the reply.

 

I guess that works fine for iscsi initiators but not fibre channel initiators.

 

Thanks

Re: cDOT CLI >igroup show

E-h-h ... what's wrong with "fcp initiator show"?

Re: cDOT CLI >igroup show

Nothing wrong with 'fcp initiator show' as long as you know the command exists - thanks