Subscribe

Error: DRQ should be zero on FAS3040

I am currently getting an error on 2 FAS3040 filers that I pulled out of storage in our datacenter. I have hooked each up seperately to a disk shelf with esh4.

Not sure what the error message means since I haven't seen this one before.

Hopefully someone has some insight on what is wrong/ I am doing wrong. Below is the boot process up to the point of error.

Phoenix TrustedCore(tm) Server
Copyright 1985-2004 Phoenix Technologies Ltd.
All Rights Reserved
BIOS version: 2.1.0
Portions Copyright (c) 2006 Network Appliance, Inc. All Rights Reserved
CPU= AMD Opteron(tm) Processor 250 X 2
Testing RAM
512MB RAM tested
4096MB RAM installed




Boot Loader version 1.2.3
Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.
Portions Copyright (C) 2002-2006 Network Appliance Inc.

Error: DRQ should be zero

Re: Error: DRQ should be zero on FAS3040

I am getting the same error on a cluster node that I have just replaced the system board on. Did you ever

get this resolved?