Community

Subscribe
Highlighted

FILESYSTEM DISK FAILED on filer

I got an error from dfm saying

General Information

-------------------

DataFabric Manager Serial Number: 1-50-111062 Alarm Identifier: 1

Event Fields

-------------

Event Identifier: 36578

Event Name: Disks: Some Failed

Event Description: Status of disk failures on an appliance Event Severity: Error Event Timestamp: 01 Aug 21:14

Source of Event

---------------

Source Identifier: 74

Source Name:

Source Type: Active/Active Controller

Source Status: Error

Event Arguments

---------------

diskMessage: Disk on adapter 2c, shelf 1, bay 1, failed.

how do i find out from the oncommand or command prompt that it did fail? what can i do?

Re: FILESYSTEM DISK FAILED on filer

You can look through the messages log file(s) for the failure. In this case, since the error was from last week, check the messages.0 file.

Or if you want to see the current status of the disk, from cli you can do a disk show command, like so:

SAN-1NETAPP04> disk show 5a.00.6

  DISK       OWNER                      POOL   SERIAL NUMBER         HOME

------------ -------------              -----  -------------         -------------

5a.00.6      SAN-1NETAPP04(2015191625)    FAILED KPHESN7F              SAN-1NETAPP04(2015191625)

SAN-1NETAPP04>

Re: FILESYSTEM DISK FAILED on filer

vol status -f

and replace the drive, call netapp open up a support case to send the drive and they will replace for you.

Thank you,

AK G