Subscribe

How to use multiple vscan servers

Hi,

 

I'm trying to use two primary vscan server for our netapp filer but I can only use one primary and one secondary.

As can be seen in the manual it is possible to use multiple primary vscan server.

 

How can I do this in  Data Ontap 8.2.2 (FAS8020) ?

 

 

 

Thx for your help. 

 

Re: How to use multiple vscan servers

Yes it's possible to have multiple primary vscan servers. Just configure the vscan servers with the filer information and allow them to connect. I've never needed to add them on the file server side. I know we looked at the 'secondaries' feature a while back but deterimed it didn't give us any advantage and instead just allow them all to connect to the filers themsevles.

 

--rdp

Re: How to use multiple vscan servers

Hi,

 

Yes, it's possible to have two primary vscan servers.  Two primary vscan servers creates a round-robin where both servers split the scanning load.

 

For more details, refer the KB article https://kb.netapp.com/support/index?id=3013679&page=content&locale=en_US 

 

 

Thanks

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

Re: How to use multiple vscan servers

I cannot open your link, i got an unexpected error message.

Can you check the link again?

Re: How to use multiple vscan servers

 

Hi Jenoptik

 

It is possible to have two primary vscan server. Following is the link from netapp KB site which explains the same process.

 

https://kb.netapp.com/support/index?page=content&id=3012425&actp=search&viewlocale=en_US&searchid=1444120524337

 

Thanks.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.