ONTAP Hardware

Issue joining FAS2020 to Windows Domain

WARHORSE24
3,255 Views

Hello all,

I have a filer that I am trying to join to an MS domain.  Connectivity has been verified but when I run the CIFS setup wizard, it fails with following error msg: Primary Domain Controller must be active for installation...oddly enough, DC is present and as mentioned earlier, can ping Filer's IP.  Any help would be greatly appreciated.

-D

2 REPLIES 2

smitchel
3,255 Views

Andre,

I think the issue you are hitting is documented in this KB article:

https://kb.netapp.com/support/index?page=content&id=2012697

Ensure that options dns.enable is on. The option dns.enable is off by default.

Thanks,

Mitchell

WARHORSE24
3,255 Views

Mitchell,

Thank you for the response.  The filer's DNSsettings were enabled, the only difference is that they set through the CIFS setup wizard. I'll use cli to see if it makes a difference.  Thanks again, and I'm hoping that my filer is just being stubborn.

-D

Public