Subscribe

Netapps newbie

Our department will be deploying some NetApp V-Serie 3100. We will use LACP to aggregate some interfaces  (2 x 2Gig) on the appliances onto to  2 Cisco 4500 Catalyst switches. Does a network loop could be created if the NetApp appliance is not configured properly

Thanks

Dr-Gilles

Re: Netapps newbie

Hi, welcome to the community.

Have a look at VIF and LACP on the now site.  Here is a good link to get you started.

https://now.netapp.com/Knowledgebase/solutionarea.asp?id=kb20148

Hope it helps

Bren

PS - We just used single mode VIFS as it is good enough for us and is much simpler.