Subscribe

Snapvault -- idle with restart checkpoint

Hello,

I am new to NetApp Snapvault.

I have one volume that will start transferring, then it stops with " Idle with restart Checkpoint"

I did snap vault start.   It started to transfer but then it stopped again.

What do I need to do to complete the snapvault?

Thanks,

Re: Snapvault -- idle with restart checkpoint

First, are you using oncommand or just doing this via the CLI

Also, check the snapmirror log in /etc/log to see what it says

Re: Snapvault -- idle with restart checkpoint

I am doing with via the CLI.

For some reason, the snapmirror log is not recording any messages.

Re: Snapvault -- idle with restart checkpoint

Ok, CLI = good IMHO

Are you snapvaulting off a mirror or just a normal volume

Re: Snapvault -- idle with restart checkpoint

I was able to fix this.  The volume had run of of space.