ONTAP Hardware

V-Filer dr configure error

kobusventer
2,379 Views

Hi Guys and Ladies

 

I have to configure a DR v-filer but get the following error in doing so - knowledgebase and support site does not give me any info.

 

vfiler dr configure source_vfiler@source_filer -u
source_filer's Administrative login: root
source_filer's Administrative password:
source_filer: Connection refused
vfiler command cannot be run while 'vfiler dr' command is running; try again later.
: Undefined error: 0

 

Can someone please tell me why I am getting this error, and what I should do to get around it?

 

Regards

 

 

1 ACCEPTED SOLUTION

georgevj
2,308 Views

Enable and configure  rsh on both source and destination, then retry.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.
Cannot find the answer you need? No need to open a support case - just CHAT and we’ll handle it for you.

View solution in original post

2 REPLIES 2

georgevj
2,309 Views

Enable and configure  rsh on both source and destination, then retry.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.
Cannot find the answer you need? No need to open a support case - just CHAT and we’ll handle it for you.

kobusventer
2,306 Views

Hi, thanks for the feedback - however, rsh is enabled on both filers. By the way - I am running DOT 8.2.3P2.

Public