ONTAP Hardware

save command

mark_zhang
2,647 Views

Hi, I tried to login sp and system console to my Netapp FAS3140. I configure my network part. But sometime I found my configuration lost after I logout.

So my question is if there are some command need to run to save my change?

Thanks!

1 REPLY 1

HARI_KRISHNA981
2,647 Views

Hi Mark.zhang,

The filer reads the /etc/rc on boot up to load the network information. You have to add it there to make any network configurations permanent.

Have you updated the changes in the /etc/rc??

Regards,

Hari.

Public