2015-04-11 10:11 PM
I am planning to upgrade my Ontap to 8.1.4 and i have downloaded the ONTAP IMAGE and i have shared ETC$ following this link :- http://www.cosonok.com/2013/09/how-to-access-etc-share-from-windows.html but i was able to map the share as drive and able to see contents in /ETC but when i tried opening the folder /etc/software it is throwing an error stating not enuff permissions
Also one more doubt i know the Ontap Image itself will have DISK SHELF FIRMWARE , Will that also have the disk qualification packages ???? Or do i need to download the disk qualification packages seperately and upgrade them ????
Solved! SEE THE SOLUTION
2015-04-12 07:06 PM
I have found the solution for this and solution is to create same user in Windows as well as in Netapp also password must be same
Example ( SAME SHOULD BE BOTH IN WINDOWS AND NETAPP )
PASSWORD :- P@ssw0rd
Please refer to this link for more information :- https://kb.netapp.com/support/index?page=content&id=1011622&locale=en_US
2015-04-14 02:59 AM
you will need to download hte disk qual package seperately and copy it to the filer.
Also did you run upgrade advisor as you may have disks that need their firmware upgraded prior to the ontap image upgrade
2015-05-07 03:32 AM
i am face a problem with cluster mode 8.2.1 in open share folders. can you please tell me what ip use for open share folder . i make a cluser with two nodes and make a one svm and configure this svm with two network interface succersfully . if i opened share folder using both network interface ip then share folder open successfully . but when i open share folder using cluster or node ip share can not be opened.please tell me if you know what is the concept of share in cluster mode.