2010-04-08 11:07 AM
For the purposes of documentation I am looking for the command line steps for setting up ACP on a system that has DS4243 shelves. I remember doing this a while back and accepting the defaults for IP addresses etc, but I cannot seem to find it on the NOW site. IF you could paste that for me I would greatly appreciate it. As I recall I did an options acp.enable on and then from there there was another command that accepted user prompts for the setup.
2010-04-09 12:55 AM
This is for verifying the setup you did : http://now.netapp.com/NOW/knowledge/docs/ontap/rel732/html/ontap/setup/frameset.html