Subscribe

BMC problem connecting to FilerView / System Manager

Hi,

I have a problem, I recently downloaded the software OnCommand System Manager, but do not get it to work, not really get it to work the BMC connection via HTTP or SNMP in any way. I rebooted the BMC console dede I checked its configuration, HTTP mode ison, the ip responds to ping, (SSH is off) I connected directly to the FAS2020 by ethernetto rule out problems with the switch but either.

You do not say this is the first time I try to connect via http to the cabin to manage,

Thanks,

Regards

Re: BMC problem connecting to FilerView / System Manager

The system is FAS2020 ONTAP 7.3.2

Re: BMC problem connecting to FilerView / System Manager

Is HTTPS enabled on the controller? options httpd.admin.ssl.enable and secureadmin to setup it (if not already done).

Re: BMC problem connecting to FilerView / System Manager

HTTPS is the same as httpd.admin.ssl.enable? if so is not enabled, SSL v1 and v2either, you have to do with SecureAdmin? how to configure this?

Thanks

Regards,

Re: BMC problem connecting to FilerView / System Manager

httpd.admin.ssl.enable set on just after you setup with ssl SecureAdmin and as usual not connecting.


thanks


regards,

Re: BMC problem connecting to FilerView / System Manager

secureadmin is the command to setup ssl

karthikv-DOT7m-v1> secureadmin

Usage:

        secureadmin setup [-f] [-q] ssh

        secureadmin setup [-f] [-q] ssl

        secureadmin addcert ssl [<path to CA signed cert>]

        secureadmin enable  all|ssh|ssh1|ssh2|ssl

        secureadmin disable all|ssh|ssh1|ssh2|ssl

        secureadmin status

man secureadmin should give you more details on the command, how to set it up and what various options mean.

Regards,

Karthik

Re: BMC problem connecting to FilerView / System Manager

Other question: Maybe change the network configuration of the BMC to avoid problems with firewalls and switches, the idea is to change it to 192.168.9.X192.168.0.X network if they performed this hurts something NFS performance the cab or the BMC is completely independent and the changes it does not affect the rest of the car running? I understand that is independent but would like confirmation


thanks


regards,


David

Re: BMC problem connecting to FilerView / System Manager

If you mean baseboard management controller on FAS2020, the only protocol it supports is SSH.

Re: BMC problem connecting to FilerView / System Manager

I refer to the BMC that is second from the left which is next to which is connected with serial cable that has the symbols IOIO, below is a drawing of a wrench.


You can only SSH? I thought that also HTTP, in fact I think we have licensed.

Re: BMC problem connecting to FilerView / System Manager

BMC is independent piece of hardware and is unrelated to Data ONTAP; it runs besides and in parallel to it.

Once more - the only network protocol that is supported by BMC is SSH.