2015-11-20 06:00 AM
Some of the data sources are failing with the error:
"Inventory Package has reported conflicting device(s)" .I found some solutions stating that the device is being reported by multiple data sources.
Is there any other reason for such kind of errors. What is the solution to fix this error.
Solved! SEE THE SOLUTION
2015-11-26 03:24 AM
It looks like the same device is being discovered more than once by multiple datasources, hence leading to the error messages.
This is most likely due to the configuration setting “Discover all Fabric switches”. You can either create one datasource for each FC switch or you can configure one datasource per Fabric (and then turn on the Discover all Fabric switches feature). If you have done the former and have this setting enabled, you may run into this issue.
If this is the case, you may want to “Edit” the corresponding datasource and uncheck the “Discover all Fabric switches” checkbox and see the issue status. Once the datasource is automatically reconfigured after the change, the message should ideally disappear.
2016-02-09 12:30 PM
That is correct the device is being monitored by more than one datasource.
Inventory Package has reported conflicting device message within OCI Data Source Report
OnCommand Insight (OCI)
The following error message in Red on your data source report is displayed:
|London_S219596SSAU0001||ok||TRUE||London_s219596c9124f9002||Inventory||Tue 01/05/16 03:48 AM||Cisco||All models using SNMP||Inventory Package has reported conflicting device(s)|
Multiple collections cause undue CPU and memory cycles on both the OCI server and the device itself.
We have one or more Data sources collecting on the same device or devices.
The latency and slow device is caused by response by these unnecessary duplication of effort.
Duplicates have also been known to cause DWH ETL failure as well and in older version's of OCI DB corruption.
Determine which other Data Sources are collecting on the same device and use the exclusion feature within the Data Source configuration to correct the multiple collections.
NetApp provides no representations or warranties regarding the accuracy, reliability, or serviceability of any information or recommendations provided in this publication, or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS, and the use of this information or the implementation of any recommendations or techniques herein is a customer’s responsibility and depends on the customer’s ability to evaluate and integrate them into the customer’s operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
When 7. 2 releases you will need to add the widget below