Subscribe

Oncommand System Manager for Data Ontap 7.0.6

Hi all,

I installed software OnCommand System Manager 2.0.1. But it can not connect to FAS250 ( Data Ontap 7.0.6 ).

How can i use the OnCommand System Manager to connect and manage FAS250.

The Error is :

Version 1.7 was requested, but only 1.4 is supported. (Error: 13010)

I will appreciate all your answer.

Thanks so much

Re: Oncommand System Manager for Data Ontap 7.0.6

Update to the current Data ONTAP 7.3.7. 7.0.6 is really old.

Re: Oncommand System Manager for Data Ontap 7.0.6

Hi aborzenkov,

Could you please instruct me how to upgrade Data Ontap FAS250 ?

Will my data on Fas250 be lost when upgrade Data Ontap ?

Thanks so much

Re: Oncommand System Manager for Data Ontap 7.0.6

Your data won’t be lost.

You can find detailed description in Upgrade and Revert Guide for target Data ONTAP version as well as in Upgrade Advisor in My Autosupport.

Re: Oncommand System Manager for Data Ontap 7.0.6

Hi aborzenkov,

I can not find Upgrade Advisor, seem it is removed .

Thanks for your help

Re: Oncommand System Manager for Data Ontap 7.0.6

Hi 

1. fas1> options lun.use_partner.major_ndu_compatibility on
But My Fas 250 didn't have this command. It has command lun.use_partner.cc.enable

     fas1> options lun

     options lun

     lun.use_partner.cc.enable    on

And the Step 4:

Connect to the console of the node and trigger an AutoSupport:

fas1> options autosupport.doit starting_NDU

- What is starting_NDU ? Can i run these command from ssh ( because i don't have console cable )

Could you please help !!! I am begin learning Netapp so i don't have much knowledge about it.

Thanks so much

Re: Oncommand System Manager for Data Ontap 7.0.6

Some options are not visible until you set them. Just try to set it. Although I am not sure this option matters at all, because FAS250 does not support either active/active configuration or FCP.