2015-06-30 02:02 PM
I have the to discover snmp after configure SNMP. Even I tried both trap hosts with my windows IP where I installed Oncommand system manager and the IP of Ontap 7.3.7. Can someone please verify which host is correct one? what is the requirement for SNMP configure.
2015-07-01 02:56 AM
2015-07-01 01:40 PM
Thank you so much for your reply. I can not access the link in your message
Anyway, I tried to run WireShark and see the SNMP package sent from a client to Netapp FAS2020 is fine, but when the Netapp respnsed, it's failed, and then to ssh to netapp and ping out to the client, but it's failed. Do you know anythig with it?
2015-07-01 07:11 PM
Sorry, access for this KB is restricted. Then, check following point and fix them.
1. Check if SNMP agent is enabled.
filer> options snmp.enable
If not, enable it by "options snmp.enable on"
2. Check if SNMP access is allowed.
filer> options snmp.access
If IP address of System Manager host is not listed, set it by "options snmp.access host=<IP address>"
3. Check filer's SNMP community name.
filer> snmp community
By default, "ro public" is displayed.
If you have modified SNMP community name, you need to modify registration on System Manager.
Edit C:\Users\<username>\NetApp\SystemManager\SystemManager.config and adjust snmp-community
element under storage-system element.