Subscribe
Accepted Solution

Volume Capacity Used vs Total graph - Dedupe space savings not shown

When looking for reporting on Deduplication I'm experiencing the following problems:

- Selecting the report "Volume Space Savings - Deduplication......." generates no data.  The notification as show in the screenshot below states that there are no volumes.

- Selecting the report "Volume Capacity Used........" generates a graph, but  Dedupe space savings is not shown on this graph.

Re: Volume Capacity Used vs Total graph - Dedupe space savings not shown

did you configure a account to connect to the filers? Some information is collected via SNMP, but some info is collected via SSH or RSH  regards Michel

Re: Volume Capacity Used vs Total graph - Dedupe space savings not shown

Do you have a volume with dedupe enabled in your setup. Dedupe report should show the data only if you have volume with dedupe enabled in your setup.