2014-09-09 06:03 AM
I'm in process of creating a workflow that will increase a volume size (that done) but need to increase the destination volume when that volume is in a snapmiror state.
Does any one know how to figure out with WFA is a volume have a mirror ???
increase volume -> verify if he have snapmirror -> if yes -> incease destination
-> if no -> disable command
2014-09-09 10:19 AM
You can identify a volume that has snapmirror with WFA, this is done using filter.
The size of the mirror volume increases based on the transfers that you do from the source volume, i don't think you can increase the size of the mirror volume.
Please give me your requirement in detail.
Thanks & Regards,
Majid M A
2014-09-09 10:26 AM
how do you do the filter, for what i see there no vol options that chnage when the volume is in a snapmirror state !!!
the destination is if DP mode but the source noting special.
can you provide me thye filter