Ndmpcopy visibility error

Ndmpcopy_Visibility_Error — Wed, 04 Jun 2025 11:05:08 GMT

I have an error when using ndmpcopy, somebody can helpme?

Log: Volume Visibility check failed for volume

system node run -node DSIPMXNAS01-01 -command ndmpcopy -sa ndmpuser -da ndmpuser 10.48.202.103:/SVM_NAS01_01_CIFS/vol_NX_Arranque/.snapshot/weekly1/IQTITRENDVIEW/
Ndmpcopy: Starting copy [ 136 ] ...
Ndmpcopy: 10.48.202.103: Notify: Connection established
Ndmpcopy: 10.48.202.103: Notify: Connection established
Ndmpcopy: 10.48.202.103: Connect: Authentication successful
Ndmpcopy: 10.48.202.103: Connect: Authentication successful
Ndmpcopy: 10.48.202.103: Log: Session identifier: 65735
Ndmpcopy: 10.48.202.103: Log: Session identifier: 65740
Ndmpcopy: 10.48.202.103: Log: Volume Visibility check failed for volume vol_vmwiso on vserver SVM_NAS01_02_NFS
Ndmpcopy: Connection setup for transfer failed
Ndmpcopy: Done

Re: Ndmpcopy visibility error

Ontapforrum — Fri, 12 Jun 2020 18:36:38 GMT

Hi,

Are you running ndmpcopy from node-scope, following is an example of node-scope.

::> system services ndmp node-scope-mode status
NDMP node-scope-mode is enabled.

If so, then I would like to verify if you are running ndmpcopy command from the NODE which hosts the Volume you are writing to ?

I mean : Is this volume = "vol_vmwiso" on this Node:DSIPMXNAS01-01 ?

Try runing the ndmpcopy command from the Node, where this volume's ("vol_vmwiso") aggregate is hosted and choose the LIF local to that Node.

I am just guessing, looking at the error "visibility check fail" could be due to the fact that under node-scope, it can only see volumes local to the Node you are running ndmpcopy command.

Thanks!

topic Re: Ndmpcopy visibility error in Data Protection

Ndmpcopy visibility error

Re: Ndmpcopy visibility error