topic Re: SnapCenter Powershell Command iSCSI in Data Protection

SnapCenter Powershell Command iSCSI

NEPLUSULTRA — Wed, 04 Jun 2025 10:21:40 GMT

Are there powershell command that i can run on a host to

1. establish an iSCSI session

2. connect the lun

In snapdrive i can run the sdcli command. But i can find the same commands in snapcenter

https://library.netapp.com/ecm/ecm_download_file/ECMLP2874310

Re: SnapCenter Powershell Command iSCSI

mrahul — Tue, 15 Jun 2021 11:47:09 GMT

SnapCenter leverages the same commandlets via the snapdrive PS modules which gets installed as part 'SnapCenter Plug-in for Windows' Installation. Access your windows host and you can use the cmdlets.

Re: SnapCenter Powershell Command iSCSI

NEPLUSULTRA — Tue, 15 Jun 2021 12:24:08 GMT

i had a look at this one https://library.netapp.com/ecm/ecm_download_file/ECMP1189424 but i don't see powershell commands to establish an iscsi session.

Re: SnapCenter Powershell Command iSCSI

mrahul — Tue, 15 Jun 2021 13:52:07 GMT

For establishing and terminating iscsi sessions you can use SnapCenter cmdlets "Connect-SdIscsiTarget" and "Disconnect-SdIscsiTarget" respectively.

'New-SdStorage' Provisions dedicated disks, shared disks and clustered shared volumes on a LUN

'Connect-SdStorage' cmd connects a dedicated disk, shared disk, or a clustered shared volume based on a LUN.