topic Re: Snapmirror between two C190 clusters using ONTAP 9.8P4 is very slow. in Data Protection

Snapmirror between two C190 clusters using ONTAP 9.8P4 is very slow.

RuleS — Wed, 04 Jun 2025 10:04:11 GMT

This is our primary NetApp at site CapeTown and were running a SVM-DR relation to a Netapp cluster in Centurion (1500Km). From that DR-site we run a snapvault to another destination. Around 3 weeks ago we started to get problems with update of one volume in a SVM-DR. We tried to restart snapmirror relation, do a resync and all operations we could think of except running a new baseline since the WAN link is poor so we definetly want to avoid that. Nothing helped and we decided to change backup method and run a snap vault directly between primary site and backupsite and completely skip the SVM-DR relation. The snapvault relations are rebuilt at destination site and the source path is now set to the primary system. All “new” relations are now in a resync and hung.

After troubleshooting DR-site, snapvault destination, cluster peer status, WAN link and found all that OK I stared to look at the source NetApp cluster. It seems the problem is here and the system does not deliver any data during a snapmirror. I’ve setup several local test snapmirror relations within the same box. It’s no problem to establish the relation but I get basically no data transferred/copied. There is enough space in the aggregates and it is very low utilization of the cluster over all.

Here a baseline been going for 3 days and moved 82GB.

I run the same test in another C190 and a baseline of 100GB took around 3min. to complete.

Next step what is going to happen is upgrading the ONTAP from 9.8P4 to 9.8P8 tomorrow night.

Any suggestions please?

Re: Snapmirror between two C190 clusters using ONTAP 9.8P4 is very slow.

AlexDawson — Tue, 08 Mar 2022 04:33:53 GMT

Packet loss or link MTU mismatch would be my guess.

Use the network performance test feature between the two intercluster LIFs to check link throughput - https://docs.netapp.com/us-en/ontap/performance-admin/measure-latency-throughput-nodes-task.html

Then, use ping with different packet sizes to check path maximum transmittable unit (PMTU) - https://docs.netapp.com/ontap-9/index.jsp?topic=%2Fcom.netapp.doc.dot-cm-cmpr-960%2Fnetwork__ping.html - start at 1000 with -disallow-fragmentation and increase at 100 bytes per test to see when it stops working, then make sure the LIFs on both sides are set to a smaller value than that. They may be set to 1500 and your PMTU might be 1460 or lower due to vxlan, vlan or mpls encapsulation.

Hope this helps!

Re: Snapmirror between two C190 clusters using ONTAP 9.8P4 is very slow.

tahmad — Wed, 23 Mar 2022 05:03:21 GMT

Were you able to fix the issue by upgrading @RuleS , or did you find any network issue like @AlexDawson suggested

Re: Snapmirror between two C190 clusters using ONTAP 9.8P4 is very slow.

RuleS — Wed, 23 Mar 2022 05:52:46 GMT

The problem turned out to be that another administrator had changed one of the options and throttled the snapmirror by setting the

global option replication.throttle.enable on

Re: Snapmirror between two C190 clusters using ONTAP 9.8P4 is very slow.

tahmad — Wed, 23 Mar 2022 06:04:43 GMT

Thank you for sharing the solution @RuleS