https://community.netapp.com/t5/Data-Protection/Problem-with-SnapCenter-clones/m-p/449694#M13971 <P>Hi all,</P><P>&nbsp;</P><P>I have just setup snap center to backup some NFS volumes attached to a Linux server and the backups are all fine but when I try to run a clone to mount a backup I am getting the issue where SC picks the wrong interface from the SVM so the host does not have access.</P><P>I have found the fix for this for a Windows host or an ESX server is to put an entry in the SMCoreServiceHost.exe.Config is there a similar config file for a Linux host or am I only to create clones and mount them manually ?</P> Wed, 04 Jun 2025 09:43:04 GMT MARK_SAUNDERS 2025-06-04T09:43:04Z https://community.netapp.com/t5/Data-Protection/Problem-with-SnapCenter-clones/m-p/449694#M13971 <P>Hi all,</P><P>&nbsp;</P><P>I have just setup snap center to backup some NFS volumes attached to a Linux server and the backups are all fine but when I try to run a clone to mount a backup I am getting the issue where SC picks the wrong interface from the SVM so the host does not have access.</P><P>I have found the fix for this for a Windows host or an ESX server is to put an entry in the SMCoreServiceHost.exe.Config is there a similar config file for a Linux host or am I only to create clones and mount them manually ?</P> Wed, 04 Jun 2025 09:43:04 GMT https://community.netapp.com/t5/Data-Protection/Problem-with-SnapCenter-clones/m-p/449694#M13971 MARK_SAUNDERS 2025-06-04T09:43:04Z