topic Re: Svm-dr move the ports. Getting an error in Data Protection

Svm-dr move the ports. Getting an error

Johan_K — Fri, 30 Sep 2022 10:53:43 GMT

Hi,

The svm is a dp destination.

I’m trying to setup an svm dr, but first it failed because the desired ports were not in the default IPspace. After that I could not move the ports in the correct IPspace.

Is there a way of doing this or do i have to create the SVM-DR again?

Re: Svm-dr move the ports. Getting an error

Johan_K — Fri, 30 Sep 2022 12:01:51 GMT

EDIT: It’s a system error stating that the lif is part of an svm-dr and can’t deleted

Re: Svm-dr move the ports. Getting an error

Ontapforrum — Fri, 30 Sep 2022 14:29:16 GMT

SVM DR resync failed with error; There are no active ports in IPspace "Default"
https://kb.netapp.com/Advice_and_Troubleshooting/Data_Protection_and_Security/SnapMirror/SVM_DR_resync_failed_with_error%3B_There_are_no_active_ports_in_IPspace_%22Default%22

https://kb.netapp.com/Advice_and_Troubleshooting/Data_Protection_and_Security/SnapMirror/SVM_DR_Destination_data_LIFs_are_hosted_by_different_ports_than_the_Source

1) Delete the current relationship and destination vserver
2) create a new destination vserver with the correct IPspace/Broadcast-domain settings
3) create a new SnapMIrror relationship
4) Initialize this relationship

Re: Svm-dr move the ports. Getting an error

Johan_K — Mon, 03 Oct 2022 12:03:28 GMT

thx, i will look into it

Re: Svm-dr move the ports. Getting an error

liu — Wed, 11 Dec 2024 08:08:21 GMT

There are no ports assigned to the broadcast domain in the IPSpace

DR CONFIG REPLICATION FAILED - Error: Cannot find ports in IPspace - NetApp Knowledge Base

Different ports are assigned to the broadcast-domains on the source and the destination.

SVM DR resync failed with error: There are no active ports in IPspace "Default" - NetApp Knowledge Base