https://community.netapp.com/t5/Data-Protection/SnapProtect-Backup-Copy-problems/m-p/100851#M4462 <P>There are two places to check under the storage policy.</P><P>Is it set to copy only specifc full jobs and was there a timeframe set as to when the backup copy should start copying.</P><P>Is there a backup copy job sitting in the job controller (and what is the state)?</P><P>&nbsp;</P> Thu, 19 Feb 2015 17:46:30 GMT jskinner 2015-02-19T17:46:30Z https://community.netapp.com/t5/Data-Protection/SnapProtect-Backup-Copy-problems/m-p/99241#M4461 <P>Storage polciy to snap, aux between datacenters with a vault, and then backup copy to tape.&nbsp; Backup and Aux work.&nbsp; However, when I kick off the backup copy, it says no jobs found even though when I look at the jobs for the copy, it says there is one to be copied.&nbsp; So I started a new backup and told it to create a Backup Copy immediately, which failed because of the pending jobs in the backup copy.</P> <P>&nbsp;</P> <P>In the Commvault world I came from, I'd have done this with Backup, DASH Copy, Aux copy.&nbsp; That was without snapshots though so it's a brave new world now.</P> Thu, 05 Jun 2025 05:17:06 GMT https://community.netapp.com/t5/Data-Protection/SnapProtect-Backup-Copy-problems/m-p/99241#M4461 HANKHILL17 2025-06-05T05:17:06Z https://community.netapp.com/t5/Data-Protection/SnapProtect-Backup-Copy-problems/m-p/100851#M4462 <P>There are two places to check under the storage policy.</P><P>Is it set to copy only specifc full jobs and was there a timeframe set as to when the backup copy should start copying.</P><P>Is there a backup copy job sitting in the job controller (and what is the state)?</P><P>&nbsp;</P> Thu, 19 Feb 2015 17:46:30 GMT https://community.netapp.com/t5/Data-Protection/SnapProtect-Backup-Copy-problems/m-p/100851#M4462 jskinner 2015-02-19T17:46:30Z