topic Initiating the powershell it throws an error" Stop-NcNode : Extra input : ignore-full-sync-warn" in Community Related Discussions

Initiating the powershell it throws an error" Stop-NcNode : Extra input : ignore-full-sync-warn"

Roopesh — Wed, 04 Jun 2025 10:52:35 GMT

When we try to initiate powershell Stop-NcNode -Name * , it throws an error :
Stop-NcNode : Extra input : ignore-full-sync-warnings

When run it using extra input : ignore-full-sync-warnings, it throws "there's no ignore-full-sync-warnings input" error

PowerShell Toolkit : 9.7.1
ONTAP Version : 9.7p6

When requested to elaborate the issue and share screen shot, he gave below details:

Currently, we’re using automation by leveraging powershell toolkit to shutdown the controllers.
The automation is working fine if I run it against ONTAP 9.6 in the NetApp lab and it’s ever used by other Customer too.

As of now, this impact our chances on the Tender because one of requirement is ability to perform shutdown using automation.

Not sure how to proceed further

Re: Initiating the powershell it throws an error" Stop-NcNode : Extra input : ignore-full-sync-

donny_lang — Thu, 24 Sep 2020 18:15:14 GMT

Can you have the customer try this (below) instead? I'm curious if that will yield different results than using the command in the screenshot.

Get-NcNode | Stop-NcNode

Note: this will shut down the entire cluster. 🙂

Re: Initiating the powershell it throws an error" Stop-NcNode : Extra input : ignore-full-sync-

anungw — Thu, 24 Sep 2020 23:22:47 GMT

it's same result, following is the screen capture:

I used the same command on other ONTAP storage with ONTAP 9.6, it's working fine.

Is there any option or anything that need to be turn on/off in ONTAP 9.7?