topic How can delete aggregate or clear aggregate config in ONTAP Discussions

How can delete aggregate or clear aggregate config

JOEY_STORAGE — Thu, 05 Jun 2025 05:46:39 GMT

Hi all!

I use the FAS3220 in cluster mode.

Two disk is failed, and the aggregate is failed.

Now I can't delete the aggregate and delete the LUN/Volume.In the Vserver, I can't find the volume/LUN on OnCommand interface. But in the CLI, I can find the record for Volume.

Need help urgency.

Re: How can delete aggregate or clear aggregate config

GLENYU5820 — Wed, 25 Dec 2013 13:15:30 GMT

Hi Liu,

If you configured the raid-dp, 2 disk failed should not be a problem.

Need details to get you out of the hole, If you have more than one aggregate, you can move the volumes to different one, and make sure nothing left at this aggregate, then try to delete it again.

If you have the support contract, suggest you to work with them via webex.

Thanks

Glen

Re: How can delete aggregate or clear aggregate config

JOEY_STORAGE — Thu, 26 Dec 2013 08:34:31 GMT

Hi!

I use the aggregate with RAID 4, and two disk is fault.

The aggregate is faulted. On interface, I can't find LUN/Volumn in vserver config, so I can't delete anything for my aggregate.

Can your help me?

Thanks!

Re: How can delete aggregate or clear aggregate config

GLENYU5820 — Thu, 26 Dec 2013 23:06:32 GMT

Hi Liu,

Did the 2 failed disks replaced?

Run a few cli for me to get to know what you have.

aggr status

version

system health status show

Thanks

Glen