Meaning of MetroCluster Status Error? (7-mode)

joycem — Wed, 04 Jun 2025 23:43:35 GMT

Can anyone provide insight on the following error message? What type of MetroCluster error may have occured to generate this message? Are there any commands I can run to find out more info?

node-01: node-02: Metro Cluster Status Error Do you wish to proceed with system start? ([n],y)

If I answer "y", the system appears to come up fine.

But the fact it is asking me, I assuming there is some sort of MetroCluster error. Trying to figure out some more specifics.

Any insight appreciated.

Thanks,

Joyce

Re: Meaning of MetroCluster Status Error? (7-mode)

ekashpureff — Tue, 21 Jul 2015 14:39:25 GMT

Joyce -

Given that I'm teaching MetroCluster for a client in India this week this post realy caught my attention !

Best guess is that there was an unkown failure of the cluster, and the systems weren't sure of the state before the failure.

It was probably a check to prevent a bad resync if there was a split brain scenario.

I'd want to check the logs on both sides of the cluster to see what happened before the break.

I probably would have isolated the down system and done this before proceeding with bringing the failed node back online.

Thank you for this timely question.

I'll probably use it as a teaching example in the morning.

I hope this response has been helpful to you.

At your service,

Eugene E. Kashpureff, Sr.
Independent NetApp Consultant http://www.linkedin.com/in/eugenekashpureff
Senior NetApp Instructor, IT Learning Solutions http://sg.itls.asia/netapp
(P.S. I appreciate 'kudos' on any helpful posts.)

topic Re: Meaning of MetroCluster Status Error? (7-mode) in ONTAP Discussions

Meaning of MetroCluster Status Error? (7-mode)

Re: Meaning of MetroCluster Status Error? (7-mode)