https://community.netapp.com/t5/ONTAP-Discussions/Getting-feedback-from-cli-commands/m-p/112958#M23920 <P>Hi,</P><P>&nbsp;</P><P>I am afraid there is no such option to enable the output for a command and disable it when needed. Usually the status is cross checked after executing the command.&nbsp;</P><P>&nbsp;</P><P>Regards,</P><P>Anoop</P> Wed, 25 Nov 2015 09:37:09 GMT Anoop 2015-11-25T09:37:09Z https://community.netapp.com/t5/ONTAP-Discussions/Getting-feedback-from-cli-commands/m-p/112786#M23896 <P>Is there anyway to configure the ONTAP cli to give you feedback when you run a command? For instance:</P><P>&nbsp;</P><P>nfs modify -vserver myvserver01 -vstorage disabled</P><P>&nbsp;</P><P>Is silent when you run it, are you able to get some kind of output like "Value changed", or "Nothing changed".</P><P>&nbsp;</P><P>Clustered ONTAP 8.3 if that matters.</P> Wed, 04 Jun 2025 22:42:18 GMT https://community.netapp.com/t5/ONTAP-Discussions/Getting-feedback-from-cli-commands/m-p/112786#M23896 LOGANMC10 2025-06-04T22:42:18Z https://community.netapp.com/t5/ONTAP-Discussions/Getting-feedback-from-cli-commands/m-p/112958#M23920 <P>Hi,</P><P>&nbsp;</P><P>I am afraid there is no such option to enable the output for a command and disable it when needed. Usually the status is cross checked after executing the command.&nbsp;</P><P>&nbsp;</P><P>Regards,</P><P>Anoop</P> Wed, 25 Nov 2015 09:37:09 GMT https://community.netapp.com/t5/ONTAP-Discussions/Getting-feedback-from-cli-commands/m-p/112958#M23920 Anoop 2015-11-25T09:37:09Z