topic init failed on failed disk replacement in ONTAP Discussions

init failed on failed disk replacement

Ballistic99 — Thu, 10 Aug 2017 19:07:40 GMT

Im pretty green and still learning alot about netapp, had a disk fail, So i replaced it with a disk i already had unowned. i have done this only a few times, but this one is giving me

Broken Details:: init failed

If i Command line in, it will say FAILED under Pool

Any thing i should try or maybe another disk?

Thanks in advanced.

Re: init failed on failed disk replacement

Sahana — Fri, 11 Aug 2017 08:04:29 GMT

Hi,

please check the disk compatibility. Please refer a similar discussion: https://community.netapp.com/t5/Data-ONTAP-Discussions/Disk-replacement-init-failed-no-physical-data/m-p/128555#M27878

Re: init failed on failed disk replacement

weiliu — Tue, 17 Dec 2024 14:11:14 GMT

You can try the following methods to solve the problem
1. Verify the DQP is up to date
If not up to date , install a new version NetApp Downloads: Disk Qualification Package
2. Remove and reinsert the disk for at least 70 seconds.