topic Re: EMS scsi.cmd.notReadyCondition in ONTAP Discussions

EMS scsi.cmd.notReadyCondition

JOHNHUI — Wed, 04 Jun 2025 10:06:55 GMT

FAS8060 display this error message....anyone know how to solve. ontap version 9.8p6

The Fibre Channel fabric management server request (GID_PT) sent from adapter 0e failed with reason code 0x9 (Server unable to perform operation), explanation code 0xa (Port type not registered), and response code 0x8001.
The Fibre Channel fabric management server request (GID_PT) sent from adapter 3a failed with reason code 0x9 (Server unable to perform operation), explanation code 0xa (Port type not registered), and response code 0x8001.
The Fibre Channel fabric management server request (GID_PT) sent from adapter 3c failed with reason code 0x9 (Server unable to perform operation), explanation code 0xa (Port type not registered), and response code 0x8001.
The Fibre Channel fabric management server request (GID_PT) sent from adapter 3d failed with reason code 0x9 (Server unable to perform operation), explanation code 0xa (Port type not registered), and response code 0x8001.
The Fibre Channel fabric management server request (GA_NXT) sent from adapter 0e failed with reason code 0x9 (Server unable to perform operation), explanation code 0x1 (Port id not registered), and response code 0x8001.

Re: EMS scsi.cmd.notReadyCondition

Ontapforrum — Wed, 29 Dec 2021 15:32:00 GMT

Take a look at this kb, could be just informational events . Please verify it once.

FCP adapter reporting "scsitarget.hwpfct.mserr" error with reason code 0x9 and and response code 0x8001 in the EMS - NetApp Knowledge Base

Re: EMS scsi.cmd.notReadyCondition

JOHNHUI — Wed, 29 Dec 2021 15:42:32 GMT

Solution

This is going to get cleaned up in the up coming ONTAP versions (9.8).
Along with it lot of unwanted ems events will be truncated as well.

Anything I need to do????

Re: EMS scsi.cmd.notReadyCondition

Ontapforrum — Wed, 29 Dec 2021 23:12:20 GMT

As long as there are no disruptions from the front-end (Applications/servers etc) and it's just EMS logging due to 'unzoned' devices you can ignore it. However, b'cos the kb says 9.8 and you are already on it, it may be worth logging a ticket with NetApp so that you are 100% satisfied.

On the side note, the MINIMUM recommended revision for your ONTAP release is : 9.8P7 and you are on P6 ? I would suggest upgrade the ONTAP to whatever up-2-date recommended version as per the best practices!