How long are alerts there for? Is it triggered and then active for 24 hours?

Northman — Wed, 04 Jun 2025 09:44:51 GMT

Yesterday I attached a DS460c shelf to a FAS2720 with HA cabling. Sysconfig command shows HA, and all the disks have path A and B (storage disk -path). But the alert "SinglePathtoDiskShelf_Alert" is still active.

I think this is ok, but for the future, should I:

A. Suppress this alert

B. Delete this alert?

Will it come back if it is valid in both cases?

Re: How long are alerts there for? Is it triggered and then active for 24 hours?

Ontapforrum — Wed, 27 Sep 2023 10:14:32 GMT

If you have checked and confirm that:

SAS cabling is correct and in MultiPath
Clear the alert

::> system health alert delete -alert-id * -alerting-resource *

You might want to check the output of these commands:

::> system health alert show

::> storage shelf show -connectivity

::> storage show disk -field path-count

However, if there is a missing path, then troubleshoot it or simply raise a NetApp ticket for a review.

https://kb.netapp.com/onprem/ontap/hardware/%22SinglePathToDiskShelf_Alert_%22and_%22DISK_REDUNDANCY_FAILED%22_Autosupport_triggered

"SinglePathToDiskShelf_Alert "and "DISK REDUNDANCY FAILED" Autosupport triggered - NetApp Knowledge Base

topic How long are alerts there for? Is it triggered and then active for 24 hours? in ONTAP Discussions

How long are alerts there for? Is it triggered and then active for 24 hours?

Re: How long are alerts there for? Is it triggered and then active for 24 hours?