Estimate Local Data Replication Rate?

henrypan1 — Thu, 05 Jun 2025 07:09:00 GMT

Dear NetApp Gurus,

I'm planning to replicating 1.5 PB data to a new filer.

Would you be kind enough to advice a method to estimate the local replicate rate, so the total time needed could be based on?

Thanks in advance & looking forward to hear from you soon.

Good w/e

Henry

Re: Estimate Local Data Replication Rate?

scottgelb — Fri, 10 Sep 2010 18:07:03 GMT

I would use SnapMirror with multiplexing mode (2 interfaces). From the online data protection guide the example below is multi using e0a and e1a on each system and you specify the connection in the snapmirror.conf file on the target. Usually we direct attach side-by-side then use different subnets for each connection. SnapMirror handles the 2 networks and sends traffic over both concurrently. If you can sustain two gig links without impacting the source performance you could leave it open without a throttle.

name=multi(src_system-e0a,dst_system-e0a)(src_system-e1a,dst_system-e1a)

If you hav a fast system and enough resources, you could push 2x 1GB links and get near 200MB/sec with enough streams. However, 1.5Petabytes is a lot...unless my math is wrong, it would be 90+ days.

PB    1.5
TB    1536
GB    1,572,864
MB    1,610,612,736

MB/sec    200
Seconds    8,053,063.68
minutes    134,217.73
hours    2,236.96
days    93.20675556

topic Estimate Local Data Replication Rate? in ONTAP Discussions

Estimate Local Data Replication Rate?

Re: Estimate Local Data Replication Rate?