topic Eseries and tenet access ... in EF & E-Series, SANtricity, and Related Plug-ins

Eseries and tenet access ...

cedric_renauld — Wed, 04 Jun 2025 19:06:12 GMT

Hi,

I've some problems to connect to my E5624 in telent mode ...

During some tests i've do a serious multiple tests and there have put my controler in LOCKDOWN mode

For this mment I dont've any serial cable, but if I remember correctly it's possible to connect to this controler by TELNET, with a specific configuration ...

Anybody have an ideas ?

Wath is the good way to connect to my controler in TELNET ?

Thanks

Re: Eseries and tenet access ...

Sahana — Thu, 15 Sep 2016 04:25:08 GMT

Hi,

Telnet access is available to that controller, using its IP address.

Telnet will have to be enabled already. If not,

In the Array Management window's Physical tab, select the Controller you wish to grant Telnet access to.
Navigate to Hardware > Controller > Change > Remote Login.
Note: This will be made unavailable if a controller is not highlighted in the Physical tab.
In the Change Remote Login window that pops up, verify that the Enable TELNET access to Controller box is checked.