Gateway for VLAN interfaces

ZelChief — Wed, 04 Jun 2025 11:15:44 GMT

Hello!

How to configure gateway for VLAN interfaces? Found information about default gateway https://kb.netapp.com/app/answers/answer_view/a_id/1034563/~/how-to-change-the-default-gateway-to-a-new-gateway- but cant't find any information about configuration gateway for VLAN interfaces.

Re: Gateway for VLAN interfaces

Ontapforrum — Sat, 21 Mar 2020 20:23:58 GMT

Hi,

I am bit out-of-touch with 7-mode stuff, but as I remember, the routing table uses the default route when no other known route exists for a given packet's. But, you can add static route to for the destination using the following command.

How to use the route add command
https://kb.netapp.com/app/answers/answer_view/a_id/1034525

To add a route to the 10.17.250.0/24 (or whatever destination) network via 10.17.250.1, use the following syntax, using the proper value for the metric:

filer> route add net 10.17.250.0/24 10.17.250.1 1

Put that command in /etc/rc, else you will lose this route on a reboot. /etc/rc gets read at boot and sets up your network settings.

steps:
filer>rdfile /etc/rc
Copy all the text that it outputs, past it in a notepad, add the above command below the route add default, and write it back.
filer>wrfile /etc/rc
paste the edited notepad stuff.

This command overwrites the file with everything you enter at this point.

Thanks!

topic Gateway for VLAN interfaces in ONTAP Hardware

Gateway for VLAN interfaces

Re: Gateway for VLAN interfaces