topic NetApp Storage Disk Shelf. DS212C SATA disk shelf with 12 X 4TB SATA to NetApp FAS8200 & FAS8020 in ONTAP Hardware

NetApp Storage Disk Shelf. DS212C SATA disk shelf with 12 X 4TB SATA to NetApp FAS8200 & FAS8020

KRT — Sat, 17 Jul 2021 10:09:35 GMT

Hello Experts;

Hope you are all well and in good health? I have a few questions i kindly request for your expertises.

Qns 1:

When assigning ownership to Disk of DS212C of 4TB only 8disks are assigned 4 disk become shared and I can't use them for creation of aggregates

Qns 2:

Is there a way of forcing these 4 disks to be owned by single controller so that I can use them.

Kindly assist me with solutions to these challenges. Thanks alot for your help

Re: NetApp Storage Disk Shelf. DS212C SATA disk shelf with 12 X 4TB SATA to NetApp FAS8200 & FAS

pedro_rocha — Mon, 19 Jul 2021 14:44:45 GMT

Hello,

I do not see why you wouldn't be able to use those disks in the way you want. It seems they are partitioned. These are new/unused shelves, right?

Can you share the output for the below commands?

storage disk show -ownership

storage disk show -partition-ownership

If they are partitioned, you should be able to remove the partitions with the following command:

system node run -node xxx -command disk unpartition xx.xx.xx

set d

storage disk unpartition ....

Kind regards,

Pedro

Re: NetApp Storage Disk Shelf. DS212C SATA disk shelf with 12 X 4TB SATA to NetApp FAS8200 & FAS

junwang — Fri, 08 Nov 2024 08:12:58 GMT

Hi,KRT

If the hard disk status is shared, it means that these disks have been partitioned and used. If you want to allocate these disks to a node for use, you need to first unpartitione and then reassign them to the same node for use.

Use the following command to view.

storage disk show -ownership

storage disk show -partition-ownership

The command to partition is as follows

system node run -node xxx -command disk unpartition xx.xx.xx

Or enter node mode to perform split area command

disk unpartition disk_list xx.xx.xx