port available for new Stack

wolfkiler — Fri, 21 Jun 2024 09:56:12 GMT

hi Community, sorry if my question is to basic.. but any command or any way to check the ports available to add a new stack in a netapp storage using the CLI?

Re: port available for new Stack

chamfer — Wed, 26 Jun 2024 02:09:12 GMT

Hi @wolfkiler ,

I assume that you are asking about how to check the SAS ports available to add a new disk shelf stack to NetApp ONTAP based storage.

If so you can use the command "storage port show" this will list the SAS ports and those shown as "enabled" and "offline" are available for use.

There is some doco here: https://docs.netapp.com/us-en/ontap-cli-9141//storage-port-show.html

An Example of an AFFA300 that has one shelf stack connected is as below:

cluster1::> storage port show
Speed
Node               Port Type (Gb/s) State    Status
------------------ ---- ---- ------ -------- ---------------
node1
                   0a   SAS       12 enabled  online
                   0b   SAS        0 enabled  offline
                   0c   SAS        0 enabled  offline
                   0d   SAS       12 enabled  online
node2
                   0a   SAS       12 enabled  online
                   0b   SAS        0 enabled  offline
                   0c   SAS        0 enabled  offline
                   0d   SAS       12 enabled  online

topic port available for new Stack in ONTAP Hardware

port available for new Stack

Re: port available for new Stack