topic FAS 2040 IP trouble in ONTAP Hardware

FAS 2040 IP trouble

CQUILA_COZANO — Thu, 05 Jun 2025 06:48:14 GMT

Hi,

This is my first post here in NetApp, I have a little bit trouble now, I was configuring a FAS2040 (two controllers - 4eth per controller) so I need to connect those controller in redundancy with three diferents Linux Server but, I need only one ip address like a virtual address in the both controller. I attch how i like to have the connection

I hope guy's could be help me,

Cristian Quila,

Chile

[URL=http://imageshack.us/photo/my-images/688/fisoco.png/][IMG]http://img688.imageshack.us/img688/9967/fisoco.png[/IMG][/URL]

FAS 2040 IP trouble

hadrienc — Thu, 11 Aug 2011 22:03:58 GMT

Hello Christian,

If you have ethernet swithces that support LACP, we would recommand that.

1.)What you can do is use on FAS1 ethernet 1 and 2 with LACP over one switch (LACP1) and ethernet 3 and 4 with LACP (LCAP2). (same on FAS2)

2.)Then you create a single mode vif with LACP1 and 2 (active/passif)

You will have then 2gbps redundant link going to 2 different switches.

Hope that can help.

If you use Cisco switches...LACP is the channel-group command...

Regards,

Hadrien

FAS 2040 IP trouble

CQUILA_COZANO — Fri, 12 Aug 2011 14:21:46 GMT

Thx Hadrien for u answer,

So, I can have the two controller with the same IP address?? like a virtual IP address?, because I need to the Linux Servers see only one IP address

The switches are Cisco 2970 and I use LACP for the boundels

Best Regards

Topology https://dl-web.dropbox.com/get/Public/Topology.pdf?w=5115de1b

FAS 2040 IP trouble

hadrienc — Fri, 12 Aug 2011 15:02:27 GMT

Hey,

No you'll have 2 ips, one for each controller.

Check this documentation:

http://now.netapp.com/NOW/knowledge/docs/ontap/rel802/html/ontap/nag/frameset.html

You ll find everything about network configuration.

Hope this help.

Regards,

Hadrien