topic Re: Error: DRQ should be zero on FAS3040 in ONTAP Hardware https://community.netapp.com/t5/ONTAP-Hardware/Error-DRQ-should-be-zero-on-FAS3040/m-p/40926#M2849 <HTML><HEAD></HEAD><BODY><P>I am getting the same error on a cluster node that I have just replaced the system board on. Did you ever</P><P> get this resolved?</P></BODY></HTML> Wed, 30 Sep 2009 20:14:55 GMT annisquamguy 2009-09-30T20:14:55Z Error: DRQ should be zero on FAS3040 https://community.netapp.com/t5/ONTAP-Hardware/Error-DRQ-should-be-zero-on-FAS3040/m-p/40921#M2848 <HTML><HEAD></HEAD><BODY><P>I am currently getting an error on 2 FAS3040 filers that I pulled out of storage in our datacenter. I have hooked each up seperately to a disk shelf with esh4.<BR /><BR />Not sure what the error message means since I haven't seen this one before.<BR /><BR />Hopefully someone has some insight on what is wrong/ I am doing wrong. Below is the boot process up to the point of error.<BR /><BR />Phoenix TrustedCore(tm) Server<BR />Copyright 1985-2004 Phoenix Technologies Ltd.<BR />All Rights Reserved<BR />BIOS version: 2.1.0<BR />Portions Copyright (c) 2006 Network Appliance, Inc. All Rights Reserved<BR />CPU= AMD Opteron(tm) Processor 250 X 2<BR />Testing RAM<BR />512MB RAM tested<BR />4096MB RAM installed<BR /><BR /><BR /><BR /><BR />Boot Loader version 1.2.3<BR />Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.<BR />Portions Copyright (C) 2002-2006 Network Appliance Inc.<BR /><BR />Error: DRQ should be zero</P></BODY></HTML> Thu, 05 Jun 2025 07:31:53 GMT https://community.netapp.com/t5/ONTAP-Hardware/Error-DRQ-should-be-zero-on-FAS3040/m-p/40921#M2848 JGOLDBERG411 2025-06-05T07:31:53Z Re: Error: DRQ should be zero on FAS3040 https://community.netapp.com/t5/ONTAP-Hardware/Error-DRQ-should-be-zero-on-FAS3040/m-p/40926#M2849 <HTML><HEAD></HEAD><BODY><P>I am getting the same error on a cluster node that I have just replaced the system board on. Did you ever</P><P> get this resolved?</P></BODY></HTML> Wed, 30 Sep 2009 20:14:55 GMT https://community.netapp.com/t5/ONTAP-Hardware/Error-DRQ-should-be-zero-on-FAS3040/m-p/40926#M2849 annisquamguy 2009-09-30T20:14:55Z